Pump action kit for AEA HP Max Ss. 357. Order to make. Choose your color. USA

  

This is the final version. The beta test was succesful!

For figuring out dimensions and providing cool photos! A custom 1st one that I know of. A pump action kit for my AEA SS357 MAX!!! It worked right out of the box!!! Great communication and he's a 3d blueprint artist!!!

Pump action kit for AEA HP max. It works well with original round magazine.

For other models (45, 50, 51, air rifle or pistol), check my other items. The bottom pica rail receives universal verticle handle or bipod, howereve it's easier to do the puming by puting your hand in front of the bottom pica rail, grab the slider and pull/push. Soon I will make stubby forgrip for this slider to enable pumping by grabing the grip. The material is hard rubber-like so the pica rail won't be uncomfortable (at least to me). The kit for sale includes a front slider, a hoop, and a rear dovetail clamp, as shown in the picture.

An extra long bolt handle is necessary, included (will be made of stainless steel for smoothness, not in picture). Airgun and bipod are not included.

The forehand slider Is 3D printed with solid premium tough filament at100% (max allowedby printer) infil, The slider comes assembeled with a carbon fiber /stainless steel composite tube. A pusher made of aluminum alloy is another critical part in the kit. The rear dovetail adaptor is 3dprinted with solid carbon fiber PC at 100% infill. Both parts need to be installed for proper functioning.

Instrunction will come with the kit, and you can refer the the youtube video below. I offer post-sale help including replacement of faulty parts or modification if needed for functioning. You can choose the color of the front slider. Rear adaptor is always black---I believe carbonfiber PC is the best materiual for the purpose.

Note: I can do resonable modifications to the front slider, including adding or removing pica rails, adding or removing letter, etc. Allow 3-5 days to make. Those premium filaments takes 30 hours to print to achieve high strength. I always have one set in stock--just ask since the color is normally gray or black which may not be your choice. Installation: (similar to my other pump action kit).

Attention: make sure to tighten up the set screw on top of the rear u- shaped clamp so that the clamp won't move. Check and retight the screws couple days after initial installation. It should all set after 2 checks. It takes some practice to get famaliar. One tip is that if the 1st cycle went wrong, don't try to cycle twice or you will get double load and have to use a rod to remove jammed pellets. It may happen to original bolt action too. A bit silicon grease on the bolt handle-pusher hoop helps a lot to make it smooth.